Sony Xperia Z3+ Dual Teardown

In this guide, I’ll explain how to disassemble the Sony Xperia Z3+ Dual to remove the back cover, battery, camera, speaker, and motherboard.

Follow us on Facebook for the latest updates from MyFixGuide.com.

The first step is to open the dust cover on the left side.
Remove the NANO SIM card tray. Heat up the back cover and remove the back cover with suction cups.

Sony Xperia Z3 + Dual uses a tempered glass back cover. It is very flat and smooth. The surface of the back cover with a special waterproof coating, when the rain hit the back cover, the rain will quickly gather to teardrop-shaped.

Now, you can access internal components, including the battery, camera, speaker, and motherboard.

Disconnect all the cables. Remove the battery.

Xperia Z3 + Dual uses a 3.8V, 2930mAh battery, battery model AGPB015-A001, manufactured by  HanrimPostech Nanjing, using LG Chem cells.

Remove all screws. You can remove the motherboard.

Now, remove all small components from the phone body.

The 3.5mm headphone jack is specially customized by ALPS.

The back of the handset is also affixed with waterproof foam.

Wireless antennas

Rear camera and front camera

Speaker module

The 5.2-inch IPS display comes from AU Optronics, with a resolution of 1920X1080. The LCD panel model is H515DAN03.0.

Red: Qualcomm Snapdragon 810 MSM8994 processor + Samsung 3GB DDR3 SDRAM
Green: Qualcomm PM8994 power management chip
Yellow: Silicon Image WCD9330 audio decoder chip
Brown: Qualcomm Sil8620 HD output chip

Toshiba THGBMFG8C4LBAIR 32GB ROM
NXP PN544 NFC chip
Qualcomm PMI8994 power management chip
Qualcomm WTR3905 Low-power RF radio frequency receiver
Qualcomm QFE1040 diversity antenna switch
Qualcomm QFE3335 Independent RF power amplifier
Qualcomm QFE3345 Independent RF power amplifier
Qualcomm QFE1035 antenna switch
Qualcomm QFE1045 antenna switch

For more guides, check out the Sony Xperia Z3+ Dual device page.