Meizu Pro 6 Plus was launched in November 2016. It has a 5.7-inch touchscreen with a resolution of 2560 x 1440.
The Meizu Pro 6 Plus is powered by a 2GHz octa-core Samsung Exynos 8890 processor with 4GB of RAM. The phone contains 64GB of internal storage, which cannot be expanded. It has a 12MP rear camera and a 5MP front camera for selfies.
The Meizu Pro 6 Plus runs Android 6.0 and is powered by a 3400mAh non-removable battery. It measures 155.60 x 77.30 x 7.30 mm and weighs 158g.
The Meizu Pro 6 Plus is a smartphone that supports Dual SIM and Dual Standby. Connectivity options include Wi-Fi, GPS, Bluetooth, NFC and 4G. Sensors on the phone include the proximity sensor, accelerometer, and ambient light sensor.
Tools needs: screwdriver, tweezers, pick, suction cup.
Before the disassembly process, you will need to remove Meizu Pro 6 Plus’s SIM card slot.
Remove two screws close to the USB Type-C port of the phone with a screwdriver.
The back cover of the Meizu Pro 6 Plus is fixed to its body with clips. Use a suction cup and pick to separate the back cover from the body.
Use the pick to separate the back cover along the edge.
The back cover uses contact to complete some of the functional requirements of mobile phones, with no cable connected to the body, and it is very neat and tidy.
Independent key contacts, volume keys, and power button
The Meizu PRO 6 Plus rear antenna integrates NFC, MIMO, Wi-Fi, and GPS.
Meizu PRO 6 Plus’s ring 10-LED dual color temperature flash fills the light natural uniform. The middle is the laser-assisted focus.
The top also has a noise-cancelling microphone radio hole.
Remove ten screws securing the motherboard.
One of the screws is covered with a fragile label. If damaged, you will void the warranty.
The battery connector and main FPC are reinforced with a metal sheet.
Disconnect the LCD cable and coaxial cable from the motherboard and take out the motherboard from its board.
Synaptics touch chip
The earpiece is fixed on the phone’s body with glue.
Rear camera: 12MP, F/2.0, four-axis optical image stabilization of a clear and stable, 6-piece lens
Front camera: 5MP, F/ 2.0, 5-piece lens
1. RAM + SoC: Samsung SEC 634 K3RG2G20CM
2. SKYWORKS 77646-51 CDMA WCDMA 4G multi-mode multi-band power amplifier module
3. Multimode Multiband Power Amplifier Module for Quad-Band GSM/EDGE – Bands (1, 25, 3, 4, 26, 8, 13, 12, 20, 28, 34 and 39) WCDMA/HSDPA/HSUPA/HSPA/LTE
4. SKYWORKS 77807-8 FDD / TDD LTE four-band power amplifier module
5. Texas Instruments BQ25892 charging chip
The Meizu PRO 6 Plus has a 3400mAh lithium-polymer battery secured with double-sided tape. Its model number is BT66, and it supports mCharge fast charging technology.
The bottom board also has a fragile label. The speaker takes up most of the space.
The bottom board has a USB port, headphone jack, main MIC, vibration motor, HiFi, etc.; the USB Type-C port supports USB 3.1 standard, faster transmission, and the maximum also supports 24w charging.
The vibration motor
Meizu Pro 6 Plus’s HiFi module has an ESS ES9018K2M decoder chip and an ADI AD45275 op-amp chip.
The Meizu mTouch fingerprint module supports heart rate detection.
